Weighbridge, electronic platform scale, weighbridge manufacturer---three essentials for operation specifications
2018-1-10 Jiujin Weighing Apparatus Factory
1. Confirm whether the weighbridge is in the correct position (the position of the load cell), whether the anti-collision screw is set correctly (confirm that it is 2~3cm away from the wall ), and remove the debris on the Anhui platform scale;
2. After the signal line of the weighing display is accurately connected with the scale body of the weighbridge, turn on the power supply, preheat for 5~10 minutes, and check whether the weighing display is working normally;
3. Allow the overweight vehicle to slowly drive to the weighbridge. After the stagnation stop, the driver and others should evacuate the vehicle. The SBC personnel input the accurate information of the overweight vehicle according to the weighing indicator and save it.
Electronic Weighbridge Foundation: Concrete foundation must be poured. This foundation must be excavated below the local frozen soil line. The concrete label should be ensured during construction. The embedded parts should be guaranteed to be horizontal, positional and other geometric dimensions. Make sure that the embedded parts are not displaced. After the foundation pouring is completed, it should be maintained according to the civil construction code, and the concrete can reach the design strength index before installing the electronic platform scale.
　　
If the maintenance period is to be shortened, measures such as “early strength agent†should be taken under the guidance of professional and technical personnel during construction. In order to prevent lightning, you should set a grounding pile according to local conditions, and ensure that the grounding resistance is <4 ohms. An iron pipe should be laid from the center of the weighing platform to the pound room for the signal cable.
　　
Please refer to the company's basic map for the foundation construction. The general construction period plus the basic maintenance period, the approximate time before and after, depending on the season and weather factors.
　　
Weighbridge technology: The weld seam is inspected by ultrasonic flaw detection, and the next process must be inspected to ensure that the quality of the product is reliable and reliable. After welding, the scale body module is shot blasted as a whole. Eliminate the internal stress of the weld to remove the scale, check the quality of the weld, and repair the weld to improve the quality of the product if problems are found. Surface anti-corrosion treatment, simple and beautiful, using shot blasting treatment, clear surface corrosion, improve paint adhesion is more thorough than sandblasting rust removal, and the rust removal effect is much better than sand blasting. The primer adopts a zinc-rich primer to avoid the negative anti-corrosion principle of the red dan primer, and the effective zinc is used to protect the scale body than the principle of iron displacement. The rust effect is good. The topcoat is made of polyurethane resin topcoat to connect the parts without exposing the table top.
Kn95 Mask,Kn95 Masks For Sale,Authentic Kn95 Mask,Kn95 Mask Best
Zhejiang Lanhine Medical Products Ltd. , https://www.lanheyiliao.com